| |
| |
|
|
|
|
|
R 360 SafetyController for use in mobile machines. |
|
| |
|
 |
|
| |
|
|
|
Safety technology for extreme requirements.
- SafetyController to EN 954-1, category 3.
- Extended monitoring and test routines for hardware and software.
- Safe inputs and outputs for analogue, digital, pulse and PWM signals.
- CAN interfaces with CANopen, CANsafety and SAE J 1939 protocol.
- Freely programmable to IEC 61131-3.
R 360 SafetyController
Due to its integrated hardware and software functions applications up to the safety category 3 to EN 954-1 can be controlled and monitored. Permanent checks of CPU, memory and other hardware by the operating system and the extended diagnostic functions of the outputs enable a continuous monitoring of the control process. All important system information for the application program can be found in the easy and clear programming system CoDeSys.
Via the CAN interface the units can be connected to further safe and non safety-related controllers or input/ output modules of the R 360 device family via the CANsafety and CANopen protocol.
Functions and advantages
There are functions in almost all mobile machines which may endanger material and persons. In more and more types of applications (e.g. vehicle lifts, refuse trucks) there have been clearly defined product standards for some time. The employers’ liability insurance associations also often have new requirements towards the manufacturers of machines.
For this reason there is an increasing demand for certified electronic assemblies for mobile machines. The SafetyController can be used in applications up to safety category 3.
 CR7020 - SafetyController Classic (40 E/A)
CR7505 - SafetyController Classic (24 E/A)
CR7200 - SafetyController Extended (80 E/A)
Further information Bulletin (PDF-File 617 kB).
|
|
|
|
